Group Tables
	
	The Group Tables work independently  of  the Category and
	Phase Total system. Using the Group system  allows  more 
	flexibility in the printing order of cost codes. 

	Each group is assigned a 4 character alphanumeric code, and up
	to 30 character description. 

	A report order number may be assigned to each group code. This
	assigns the printing order of this group in the Crop Analysis 
	report. Groups with the same order number will print in alphabetical
	order of the group code.

	Normally you would assign several cost codes to a group (see
	Edit Cost Code table). These would be involved in the group
	operation as you prefer. These cost codes will print in cost code
	order WITHIN their assigned Group

	While printing the report, subtotals are printed for each group.

	A blank group code is used for printing any cost codes with missing or
	invalid group codes.

	Note that if running the reports in group mode, Category totaling
	and Phase totaling (if set up) are ignored.

			Hint
	Use Savetree as you print and run some reports to see the
	results using View the Last CR report. Rearrange order levels,
	and cost code assignments, and run again.

	Also depending on the season and the activity, you may wish to 
	change the order of Groups to put the more pertinent expenses at the
	beginning of each crop.